daewoo Solar 140LC-V — General Venting

SWING MOTOR IMPORTANT If the air is not vented from the system, it will cause damage to the swing motor and bearings. NOTE: Perform this only when oil has been drained from swing motor. 1. Shut down engine. 2. Disconnect drain hose and fill swing motor case with hydraulic oil. Figure 100 3. Connect the drain hose. 4. Start engine and set throttle at "LOW IDLE" and swing upper structure slowly two full revolutions to the left and right. AIR RELEASE OF TRAVEL MOTOR NOTE: Perform this only when oil is drained from travel motor. 1. Shut down engine. 2. Disconnect drain hose (Figure 101) and fill motor case with hydraulic oil. 3. Connect drain hose. 4.

Start engine and set engine speed control dial to "LOW IDLE." Run the engine for one minute and slowly drive excavator forwards and backwards. Figure 101 GENERAL VENTING 1. After venting air from all components, shut the engine down and check the hydraulic oil level. Fill hydraulic oil tank to "H" mark on sight gauge. 2. Start engine and operate all controls again, run engine for 5 minutes to ensure all system have been vent and purged of air. Shut down engine and check hydraulic oil level again. Add oil as necessary. 3. Check for oil leaks and clean all fill and venting locations. 4-72 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual