MULTIFUNCTION GAUGE AND GRAPHIC INFORMATION When the engine starter switch is turned to "I" (ON) position, a moving excavator will appear on the screen for about 2 seconds. When the moving excavator disappears, a screen for multifunction and digital clock will sequentially appear. ARO0670L Figure 35 The engine rpm, battery voltage and hydraulic pump pressure are displayed with numeric readings and a digital clock is found in the upper portion of the display.
02/05 [MO] 11:30A Each time the display selector button (15, Figure 23) is pressed, the digital readout changes in the following sequence; Engine speed (RPM) -> Battery voltage (VOLT) -> Front pump pressure (BAR) -> Rear pump pressure (BAR). ENG SPEED RPM 1950 NOTE: See Figure 39 thru Figure 42. By using a combination of the mode selector buttons, information for filters and oils can also be displayed. ARO0160L Figure 36 The display can be set for the desired language. Refer to the “Setting Method for Main Menu” on page 2-26 for the language selection and information display method. COMMUNICATION INDICATOR Indicates the condition of communication between main controller and instrument panel.
1. Normal Condition: The symbol will sequentially move like lightening. NOTE: See Figure 39 thru Figure 42. 2. Abnormal Condition: If the symbol is not displayed, it means there is a communication error. ARO0090L Figure 37 NOTE: See Figure 38. 022-00058E Operation and Maintenance Manual Operating Controls 2-19