COMMUNICATION ERROR WARNING If a communication error is generated between e-EPOS controller and instrument panel, this screen will be displayed. 02/05 [MO] 11:30A When this screen is displayed, contact a DAEWOO distributor or sales agency. COMM. Error!! NOTE: If a communication error occurs during operation, the last mode setting is stored. E.g. power mode, work mode and auto idle are stored during failure. ARO0610L NOTE: When starter switch is turned to the "I" (ON) position during a state of communication error failure, the e-EPOS controller will default to the following modes. Figure 38 Power mode: Standard mode Working mode: Digging mode Auto idle: "ON" (Selection state) 1.
ENGINE SPEED The engine speed is numerically displayed. 02/05 [MO] 11:30A ENG SPEED RPM 1950 ARO0160L Figure 39 2. BATTERY VOLTAGE The battery voltage is numerically displayed. With the engine running, the reading should be between 26V - 30V. 02/05 [MO] 11:30A When the starter is engaged or the preheat system is being used, the voltage can temporarily drop below 24V, but this is a normal condition. BATTERY VOLT 28.5 ARO0180L Figure 40 2-20 Operating Controls 022-00058E Operation and Maintenance Manual