. OPERATION OPERATION CHECK ELECTRIC WIRING WARNING Tire size Inflation pressure [MPa (kg/cm 2 , PSI)] 26.5-R25 VLT (standard) 0.44 (4.5, 63.9) 26.5-R25 VKT (standard) 26.5-R25 XADT (standard) 26.5-R25 RL2+ (standard) 800/65 R29 (if equipped) 0.39 (4.0, 56.8) NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kg/cm 2 , 4.3 PSI) of the value in the table above. CHECK WATER SEPARATOR The water separator and fuel prefilter (1) are made one and composed of (2) to (4) in the lower section. 1.
Water and sediment on the bottom can be checked through transparent cap (2). If there is water or sediment, prepare a container to receive it under drain hose (4). 2. Loosen drain valve (3) to drain the water. 3. If fuel starts flowing out through drain hose (4), close valve (3) immediately. 3 - 77 If the fu ses frequently blow or if there ar e traces of sh ort circuits in th e electrical wiring, loca te the cause and immediately perform repairs , or contact you r Komatsu distributor fo r repairs. Keep th e top surface o f the batt ery clean a nd check the breather hole in the battery cap. If it is c logged with dirt or dus t, wash the batt ery cap to clea n the bre ather hole .
Check for damage an d wrong capacity of the fuse and any sign wiring. Ch eck also for l oose te rminals a nd tighten a ny loose parts. Check the wiring of the "batter y", "starti ng motor"an d "alternator"carefully, in particular. Always ch eck if there i s any ac cumulati on of f lammable material a round the battery, an d remove such flammable material. our Komatsu distributor for investigation and correction of any problems found.
Consult y our Komatsu distribu tor for inv estigation a nd correction o f any problems found CHECK INFLATION PRESSURE OF TIRE S Measure t he inflation p ressure with a tir e pressure gauge, while th e tires are cool, befo Check for damage or wear to t he tires a nd the rims. Check for loose wheel hub bol The prope r inflation pressure i s shown below.