. MAINTENANCE SERVICE PROCEDURE Make sure that the oil level in the brake oil tank does not go down below the mark in the sight gauge (H) while the engine is running at low idle. If the oil level goes down below (H) mark, stop the engine and raise the oil level in the brake oil tank. 5. Remove the cap from bleeder screw (1) and insert a vinyl hose. (Use a commercially available vinyl hose.) 6. Put the other end of the vinyl hose approx. 50 mm into a container of oil. 7. Loosen bleeder screw (1) approx. 3/4 turns and run the engine at low idle until no more bubbles come out from the vinyl hose. 8.
When no more bubbles come out, tighten bleeder screw (1) securely, remove the vinyl hose, then install the cap. ° F), bleed the air from the brakes. NOTICE does, the brake oil pump could be damaged. oil level so that it reaches the 4 - 66 9. Perform the warming-up operation of the engine until the torque 40°C (104°F). 10. When the torque converter oil temperature gauge rises to 40°C ( Front brake: See "BLEED AIR FROM FRONT BRAKE (PAGE 4 Center brake: See "BLEED AIR FROM CENTER BRAKE (PAGE Do not attempt to use the oil drained during air bleeding again. Such a pra equipment. Make sure that the oil level in the brake oil tank does not go down below ( 11. specified level.
For details, see "CHECK OIL LEVEL IN TRANS