BASIC SERVICE 153 W2033386 6. Disconnect both the inlet and outlet coolant lines from the aftertreatment fuel injector fittings. 7. Disconnect the aftertreatment fuel injector wiring harness connector. Remove all clips and tie straps to allow the harness to hang free. 8. Remove and discard the aftertreatment fuel injector mounting bolts and spacers, and then remove the injector from the diffuser pipe attached to the turbocharger outlet. Note: Mark the AFI orientation relationship to the diffuser. With the early-style diffuser, the AFI is positioned with the higher side of the AFI heat shield facing the turbocharger.
With the new-style diffuser, the AFI is positioned with the higher side of the heat shield facing the EGR valve. 9. Remove and discard the high-temperature gasket and steel plate gasket from the bottom of the injector. Installation 1. Install a new high-temperature gasket and steel plate gasket onto the bottom of the aftertreatment fuel injector. 2. Apply high-temperature nickel-graphite anti-seize compound to new injector mounting bolt threads and insert the bolts into the spacers. Position the injector onto the diffuser pipe (attached to the turbocharger outlet) and hand start the bolts with spacers. Note: Install the AFI as marked at disassembly.