volvo — PV776-QRG07-MP8.pdf

158 BASIC SERVICE Drive Belt Replacement and Tensioning General Information The service life of the multi-groove belts is considerably improved over other systems and allows the use of higher horsepower cooling fans. All D13F engines are equipped with multi-groove belt systems. In the dual multi-groove drive belt arrangement, the fan drive and coolant pump are driven directly from the crankshaft pulley by a 10- or 12-rib multi-groove belt. The alternator and the air conditioning compressor (if equipped) are driven off the crankshaft pulley by a six-rib multi-groove belt (Figure 71). Two automatic tensioners are used, one for the fan drive and one for the accessory drive.

The lower tensioner for the fan and coolant pump is mounted on the coolant pump housing. This tensioner applies its load counterclockwise. The upper tensioner for the alternator (and refrigerant compressor if so equipped) is mounted on the alternator bracket. The tensioner applies its load in a counterclockwise direction. Automatically Tensioned System INSTALLATION Swing the tensioner to the fully sprung position and without force, using belt tensioner tool, J 44392, place the belt over the pulleys. Do not allow the tensioner to snap against its stops. Do not pry the belt over a pulley. TENSIONING No tensioning adjustment is required.

Once the tensioner is released against the belt, the belt is tightened to optimum tension automatically at all speeds and loads. MAINTENANCE The condition of the belt and tensioner should be checked when performing preventive maintenance inspections. Belt tension levels need not be checked as long as the tensioner is in good condition and there is no evidence of a loose belt.