volvo — PV776-QRG07-MP8.pdf

BASIC SERVICE 157 W2033389 9. Inspect the injector tip to make sure it is thoroughly clean and all soot has been removed. Use a mirror if a clear view of the tip is not possible. 10. Install a new high-temperature gasket and steel plate gasket onto the bottom of the aftertreatment fuel injector. 11. Apply high-temperature nickel-graphite anti-seize compound to the new injector mounting bolt threads and insert the bolts into the spacers. Position the injector onto the diffuser pipe (which attaches to the turbocharger outlet) and hand start the bolts with spacers. 12. Secure the injector mounting bolts. Tighten the bolts according to specification. W2005656 13.

Connect the aftertreatment fuel injector fuel supply line and tighten to specification. 14. Install P-clamp bolts to secure the AFI harness and fuel line. 15. Connect all previously disconnected cables to the ground (negative) battery terminals. 16. Using VCADS/ Premium Tech Tool, (PTT) reset the AFI adaptive factor, clear codes and test the system for proper operation.