168 BASIC SERVICE Operational Check W2033400 After the valve and unit injector adjustments have been completed, check engine operation as follows: 1 Using the flywheel turning tool, bar the engine over manually two complete revolutions to ensure that no piston-to-valve contact occurs. If contact does occur, readjust the valves as needed BEFORE starting the engine. 2 Start the engine and bring it up to normal operating temperature. 3 Once normal operating temperature is attained, let the engine idle for an additional five minutes. During this time, the electronic engine management system (EMS) will perform its own cylinder balancing, resulting in smooth engine idling. Note:
Do NOT use any form of power consuming equipment, such as PTO or air conditioning, when cylinder balancing is being carried out.