Kubota — 3. Checking wheel bolt torque

EVERY 50 HOURS PERIODIC SERVICE 2. Checking operator presence control (OPC) system WARNING To avoid personal injury or death: Before checking the PTO OPC, make sure that the PTO drive shaft is disconnected from the tractor. If the buzzer does not sound during the PTO OPC check procedure, shut off the engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. The unit should not be operated until servicing is completed. (1) Shuttle shift lever (2) Clutch pedal (3) PTO clutch control switch (4) PTO gear shift lever 1. Follow the “PARKING THE TRACTOR” instructions. (See PARKING THE TRACTOR on page 10.) 2. Make sure the PTO drive shaft is disconnected from the tractor.

3. Sit on the operator's seat. 4. Start the engine. 5. Engage the PTO gear shift lever (if equipped). 6. Engage the PTO clutch control switch. The PTO should begin to rotate. Disengage the PTO clutch control switch. 7. While lifting yourself from the seat, engage the PTO clutch control switch. a. The PTO should begin to rotate and a buzzer should sound. b. Disengage the PTO clutch control switch. c. If the buzzer does not sound, shut off the engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. 8. If the PTO OPC is operating properly, shut off the engine, and reconnect the implement drive shaft to the PTO. Restart the engine per the available instructions.

1.1 Preparation before testing 1. Place all control levers in the “NEUTRAL” position. 2. Set both parking brakes, stop the engine and lower all implements. 1.2 Testing switch for the shuttle shift lever 1. Follow the “PARKING THE TRACTOR” instructions. (See PARKING THE TRACTOR on page 10.) 2. Sit on the operator's seat. 3. Shift the shuttle shift lever to the forward or reverse position. 4. Depress the clutch pedal fully. 5. Disengage the PTO clutch control switch. 6. Turn the key to “START” position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. 1.3 Testing switch for PTO clutch control switch 3. Checking wheel bolt torque 1.

Follow the “PARKING THE TRACTOR” instructions. (See PARKING THE TRACTOR on page 10.) 2. Sit on the operator's seat. 3. Engage the PTO clutch control switch. 4. Depress the clutch pedal fully. 5. Shift the shuttle shift lever to the “NEUTRAL” position. 6. Turn the key to “START” position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. WARNING To avoid personal injury or death: Never operate the tractor with a loose rim, wheel or axle. Any time bolts and nuts are loosened, retighten to the specified torque. Check all bolts and nuts frequently and keep them tight. Check wheel bolts and nuts regularly, especially when new.

If they are loose, tighten them as follows. M5091N, M5101N 111