Kubota — 1. Lubricating grease fittings

PERIODIC SERVICE EVERY 50 HOURS (1) 168 to 199 N m / 17.1 to 20.0 kgf m (2) 260 to 304 N m / 26.5 to 31.0 kgf m (3) 343 to 401 N m / 35.0 to 41.0 kgf m (1) Grease fitting (front axle support) 4. Checking tie-rod dust cover Check to see that dust covers are not damaged. If dust covers are damaged, consult your local KUBOTA Dealer for this service. (1) Grease fitting (front axle support) (1) Dust cover - both sides, LH not shown in illustration IMPORTANT : If dust covers are cracked, water and dust can cause premature wear of the tie-rod. EVERY 100 HOURS (1) Grease fitting (front axle gear case support) - both sides, LH not shown in illustration 1.

Lubricating grease fittings Apply a small amount of multipurpose grease to the following points every 100 hours. If you have been operating the machine in extremely wet and muddy conditions, lubricate the grease fittings more often. 112 M5091N, M5101N