PERIODIC SERVICE EVERY 500 HOURS 4. Replacing hydraulic oil filter WARNING To avoid personal injury or death: Be sure to stop the engine before changing the oil filter cartridge. Allow the engine to cool down sufficiently; oil can be hot and can burn. 1. Remove the drain plug at the bottom of the transmission case and drain the oil completely into an oil pan. 2. After draining reinstall the drain plug. (1) Gauge (A) Oil level is acceptable within this range. 8. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 9. Make sure that the transmission fluid does not leak past the seal on the filter. IMPORTANT :
To prevent serious damage to the hydraulic system, use only a Kubota genuine filter. 5. Checking power steering line (1) Drain plug 1. Check to see that all lines and hose clamps are tight and not damaged. 3. Remove the oil filter. 4. Wipe off metal filings from the magnetic filter with a clean rag. (1) Hydraulic oil filter (2) Magnetic filter (wipe off metal filings) 5. Put a film of clean transmission oil on the rubber seal of the new filter. 6. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 7. After the new filter has been replaced, fill the transmission oil up to the upper notch on the dipstick. 122 M5091N, M5101N