EVERY 500 HOURS PERIODIC SERVICE 2. After draining, reinstall the drain plug. 3. Fill with new oil up to the upper notch on the dipstick. (See LUBRICANTS, FUEL AND COOLANT on page 102.) 3. Tighten the filter quickly until it contacts the mounting surface. Tighten the filter by hand an additional 1/2 turn only. 4. After the new filter has been replaced, the engine oil normally decreases by a small amount. Make sure that the engine oil does not leak through the seal and be sure to check the oil level on the dipstick. Then replenish the engine oil up to the prescribed level. IMPORTANT : Use DPF-compatible oil (CJ-4) for the engine. (1) Engine oil filter IMPORTANT :
To prevent serious damage to the engine, use only a Kubota genuine filter. (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range 3. Replacing fuel filter 1. Remove the fuel filter. 2. Put a film of clean fuel on the rubber seal of the new filter. 3. Tighten the filter quickly until it contacts the mounting surface. Tighten the filter by hand an additional 1/2 turn only. 4. Bleed the fuel system. (See Bleeding fuel system on page 130.) (1) Drain plug 2. Replacing engine oil filter WARNING To avoid personal injury or death: Be sure to stop the engine before replacing the oil filter cartridge. Allow the engine to cool down sufficiently; oil can be hot and can burn. 1.
Remove the oil filter. 2. Put a film of clean engine oil on the rubber seal of the new filter. (1) Fuel filter M5091N, M5101N 121 Oil capacity with filter 10.7 L