PERIODIC SERVICE EVERY 400 HOURS (A) “AIR CONDITIONER AIRFLOW” (1) Water sensor connector (2) Fuel shutoff-valve (3) Cup (A) “CLOSE” NOTE : If the filter is very dirty: Dip the filter in lukewarm water with mild dish washing detergent. Move it up and down as well as left and right to loosen dirt. Rinse the filter with clean water and let it air-dry. IMPORTANT : Do not use gasoline, thinner or similar chemicals to clean the filter as damage to the filter may occur. It may also cause an unpleasant odor in the CAB next time the system is used. (1) O ring (2) Element (3) Element cup (4) Red float (5) Cup (6) Drain plug (7) Water sensor connector EVERY 400 HOURS 1.
Cleaning water separator This job should not be done in the field, but in a clean environment. 1. Disconnect the water sensor connector. 2. Close the fuel shutoff-valve. 3. Unscrew the cup and remove it, then rinse the inside with kerosene. 4. Take out the element and dip it in the kerosene to rinse. 5. After cleaning, reassemble the water separator, keeping out dust and dirt. 6. Connect the water sensor connector. 7. Bleed the fuel system. (See Bleeding fuel system on page 130.) IMPORTANT : If the water separator and/or fuel filter is not well maintained, the supply pump and injector may be damaged earlier than expected. EVERY 500 HOURS 1.
Changing engine oil WARNING To avoid personal injury or death: Be sure to stop the engine before changing the oil. Allow the engine to cool down sufficiently; oil can be hot and can burn. 1. To drain the used oil, remove the drain plug at the bottom of the engine and drain the oil completely into the oil pan. 120 M5091N, M5101N