EVERY 200 HOURS PERIODIC SERVICE 4. Retighten the tie-rod nut. 5. Attach the snap ring of the tie-rod joint. Pressure of compressed air must be under 205 kPa (2.1 kgf/cm 2 / 30 psi). (1) Snap ring - both sides,RH not shown in illustration (2) Tie-rod nut - both sides, RH not shown in illustration 167 to 196 N m 17 to 20 kgf m (3) Tie-rod joint - both sides, RH not shown in illustration (1) Inner air filter (A) 4. Cleaning fresh air filter Remove the knob bolts and pull out the filter. 2. Draining fuel tank water Loosen the drain plug at the bottom of the fuel tank to let sediments, impurities and water out of the tank. Finally, tighten up the plug.
(1) Fresh air filter (2) Cover (3) Knob bolt (A) Air inlet port NOTE : After cleaning, attach the filter and cover as in the previous illustration. (1) Fuel Tank (2) Drain plug 4.1 Cleaning the filter IMPORTANT : If the fuel contains impurities, such as water, drain the fuel tank at shorter intervals. Drain the fuel tank before operating the tractor after a long period of storage. The fuel tank is made of plastic. Be careful not to overtighten the bolts. Normal use Blow air from the opposite direction to the filter's normal air flow. Pressure of compressed air must be under 205 kPa (2.1 kgf/cm 2 / 30 psi). IMPORTANT : Do not hit the filter.
If the filter becomes deformed, dust may enter into the air- conditioner, which may cause damage and malfunction. 3. Cleaning inner air filter Press the inner air filter in the arrow-marked directions to unlock it and remove the inner filter, and blow air from the direction opposite to the filter's normal air flow. M5091N, M5101N 119