PERIODIC SERVICE EVERY 100 HOURS 4. When exchanging an old battery for a new one, use a battery of equivalent specification to those shown in the following table. Table 1 (1) Adjusting bolt (2) Double nuts (A) Check the belt tension 7.3 Directions for battery storage 1. When storing the tractor for long periods of time, remove the battery from the tractor, adjust the electrolyte to the proper level and store in a dry place out of direct sunlight. 2. The battery self-discharges while it is stored. Recharge it once every 3 months in hot seasons and once every 6 months in cold seasons. EVERY 200 HOURS 1. Adjusting toe-in 8.
Adjusting air conditioner belt tension WARNING To avoid personal injury or death: Be sure to stop the engine before checking the belt tension. (A) Wheel-to-wheel distance at the rear (B) Wheel-to-wheel distance at the front (C) “FRONT” 1. Stop the engine and remove the key. 2. Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the double nuts and turn the adjusting bolt to adjust the belt tension within acceptable limits. 4. Replace air conditioner belt if it is damaged. 1. Park the tractor on a flat surface. 2. Turn the steering wheel so that the front wheels are in the straight-ahead position. 3.
Lower the implement, apply both parking brakes and stop the engine. 4. Measure the distance between the tire beads at the front of the tire, at hub height. 5. Measure the distance between the tire beads at the rear of the tire, at hub height. 6. The front distance should be shorter than the rear distance. If not, adjust the tie rod length. IMPORTANT : Make sure that the V-belt tension is as specified as shown in the table above after tightening the tension pulley mounting nut. 1.1 Adjusting toe-in procedure 1. Detach the snap ring. 2. Loosen the tie-rod nut. 3. Turn the tie-rod joint to adjust the rod length until the proper toe-in measurement is obtained.
118 M5091N, M5101N Battery type Volts (V) Capacity at 5H.R (A.H) GP31(105E41R) 12 80 Reserve capacity (min) Cold cranking amps Normal charging rate (A) 160 900 11 Proper air condi- tioner belt tension A deflection of between 10 to 12 mm when the belt is pressed (98 N / 10 kg) in the middle of the span. Proper toe-in 2 to 8 mm