PERIODIC SERVICE EVERY 500 HOURS 2. Allow the engine to idle unloaded for about 5 minutes before stopping it, rather than stopping it suddenly. 3. Keep away from the machine for another 10 minutes or while the steam blows out. 4. Check that there are no dangers such as burns. Get rid of the causes of overheating according to the troubleshooting section of this manual. (See TROUBLESHOOTING on page 137.) Afterward, restart the engine. M5101N 7. Checking fuel line 1. Check to see that all lines and hose clamps are tight and not damaged. 2. If the hoses and clamps are found to be worn or damaged, replace or repair them at once. (1) Fuel lines (2) Clamp bands NOTE :
If the fuel line has been replaced, be sure to properly bleed the fuel system. (See Bleeding fuel system on page 130.) 8. Checking intake air line 1. Check to see that hoses and hose clamps are tight and not damaged. (1) Fuel lines (2) Clamp bands M5091N (1) Fuel lines (2) Clamp bands 124 M5091N, M5101N