Kubota — 2. Changing front axle gear case oil and front differential case oil

PERIODIC SERVICE EVERY 1000 HOURS 3. Re-tighten the lock nut. (1) Dipstick (2) Oil inlet (A) Oil level is acceptable within this range. (1) Adjusting screw (2) Lock nut IMPORTANT : Do not operate the tractor immediately after changing the transmission fluid. Run the engine at medium speed for a few minutes to prevent damage to the transmission. EVERY 1000 HOURS 1. Changing transmission fluid WARNING To avoid personal injury or death: Allow the engine to cool down sufficiently; oil can be hot and can burn. 2. Changing front axle gear case oil and front differential case oil 1.

To drain the used oil, remove the drain plug at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining, reinstall the drain plug. 3. Fill with new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick. (See LUBRICANTS, FUEL AND COOLANT on page 102.) 4. After running the engine for a few minutes, stop it and check the oil level again; add oil to the prescribed level. 1. To drain the used oil, remove the drain plugs at the both front axle gear cases and filling plugs, and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. 3. Remove the oil level check plug at the front differential case. 4.

Fill with the new oil of the specified amount from both filling ports on the front axle gear case. 5. Finally fill with the new oil up to the lower rim of check plug port on the front differential case. (See LUBRICANTS, FUEL AND COOLANT on page 102.) (1) Drain plug 126 M5091N, M5101N Oil capacity 52 L