Kubota — 15. Shuttle shift lever

STARTING THE TRACTOR OPERATING THE TRACTOR 12. Travel speed limiter The torque of the wheel axle is extremely high while creep speed is being used. Be sure to step down on the clutch pedal completely before applying the brakes, or they will not work. When starting to operate the tractor, be sure to release both parking brakes. Misuse of the brakes may cause damage to the transmission and is therefore not acceptable to KUBOTA for coverage under the warranty. The highest travel speed is reachable when the engine rpm is at around the middle level with the maximum travel speed range. This provides for a fuel-efficient run while traveling along roads, pulling a trailer, and so on.

Step on the foot throttle, and the engine rpm rises proportionally and the travel speed goes up accordingly. But the engine speed is limited to 2095 rpm or so, and it does not increase even if the foot throttle is increased. When the main gear shift lever is set to the [H-6] position, the rev-limiter indicator illuminates. IMPORTANT : Press the clutch pedal completely down and stop the tractor's motion before shifting the range gear shift lever. to obtain low speeds. This shifting requires clutch operation. Shift the range gear shift lever to (1) Rev-limiter indicator 13. Main gear shift lever The main gear shift is fully synchronized to shift without stopping. IMPORTANT :

The main gear shift may be shifted between speeds on-the-go, but the clutch must be depressed. (1) Range gear shift lever Creep speed should be used only when doing one of the following jobs: Deep rotary-tilling and harrowing Planting Turf application Creep “ON” 14. Range gear shift lever The range gear shift can only be shifted when the tractor is completely stopped and the clutch is depressed. Creep speed cannot be used for any of the following jobs: Pulling a trailer Front-loader operation Front-blade operation Earth-moving Entering and leaving a field Loading onto and unloading from a truck IMPORTANT :

To avoid transmission damage, depress the clutch pedal and stop the tractor before shifting between ranges. 14.1 Creep speed 15. Shuttle shift lever WARNING To avoid personal injury or death: When you leave the tractor, be sure to apply both parking brakes and stop the engine. In applying the brakes: WARNING To avoid personal injury or death: If the shuttle shift lever is moved in forward or reverse position while the gear-locked parking brake is applied, an alarm buzzer will sound. M5091N, M5101N 51