LCD MONITOR OPERATING THE TRACTOR 1. Press the mode selector switch to choose “Tire circumference” . Then press the select switch, and the tire circumference setting screen appears. The various setting mode screen appears again. 1.4 Setting the unit 1. Press the mode selector switch to choose “Unit setting” . Then press the select switch, and the unit setting screen appears. (1) Tire circumference (1) Unit setting (1) Tire circumference screen 2. According to the following table, enter the tire circumference value. a. Press the mode selector switch to select a digit. b. To put the number forward, press the select switch. The numeral changes from 0 to 9 at each push of the switch.
(1) Unit setting screen 2. Press the select switch to select or . 3. Press the mode selector switch. 4. To complete the setting, select with the select switch. The various setting mode screen appears again. Tire circumference table (reference) 1.5 Setting the PTO speed display 540/540E rpm model The PTO speed display mode has been factory-set at “540/540E” . Do not attempt to change the setting. Otherwise the correct PTO speed will not be displayed on the LCD monitor. 540/540E/1000 rpm model The PTO speed display mode has been factory-set at “540/540E/1000” . Do not attempt to change the setting. Otherwise the correct PTO speed will not be displayed on the LCD monitor. 3.
Press the mode selector switch. 4. To complete the setting, select with the select switch. M5091N, M5101N 59 Rear tire size Entry (cm) Rear tire size Entry (cm) 230/95R32 398 360/70R28 392 230/95R36 429 380/70R24 375 320/85R24 364 380/70R28 406 320/85R28 395 440/65R24 372 340/85R28 405 440/65R28 403 360/70R24 361