OPERATING THE TRACTOR PARKING THE TRACTOR When Constant RPM Management is Fluctuations in the engine speed due to load fluctuations are reduced and the travel speed and PTO speed are kept nearly constant, allowing stable work. When Constant RPM Management is , the switch's indicator lights up. PARKING THE TRACTOR When parking the tractor, set both the parking brake lever and the gear-locked parking brake lever. WARNING To avoid personal injury or death: Before dismounting tractor Always set both parking brakes and lower all implements to the ground. Leaving the transmission in gear with the engine stopped will not prevent the tractor from accidental rolling.
Stop the engine and remove the key. When Constant RPM Management is As in a conventional engine, the engine speed increases or decreases according to changes in the load. The operator judges the size of the load from the engine speed and engine sound, and can adjust the travel speed or plowing depth to prevent overload on the tractor. 1. Before getting off the tractor: a. Disengage the PTO. b. Lower all implements to the ground. c. Place all control levers in their neutral positions. d. Pull the parking brake lever up to the parking position. (1) Constant RPM Management switch with indicator NOTE :
In a mechanically-controlled engine, the engine speed changes according to increases and decreases in the load. For example, when working in a hilly area, the load increases and engine speed drops while ascending a slope, and conversely the engine speed increase and the load drops when descending. These changes in engine speed affect the travel speed and PTO-driven implements. In order to minimize these effects, the operator must make fine adjustments to the travel speed and hand throttle lever.
When the Constant RPM Management switch in this tractor with its electronically controlled engine is turned , the engine speed will be kept nearly constant in response to a certain level of load fluctuations. This improves the accuracy of work without the need for troublesome manipulation of the travel speed and hand throttle lever. There is a limit to the range within which a constant speed can be maintained. If a load exceeding the engine performance is applied, the engine speed will drop. The purpose of Constant RPM Management is not to increase the engine power. (1) Parking brake lever (2) Release button (A) “Pull up to parking position” e.
Pull the gear-locked parking brake lever to the parking position. (1) Gear-locked parking brake lever (A) “Pull to parking position” f. Stop the engine. g. Remove the key. 64 M5091N, M5101N