Kubota — 2. Constant RPM Management control

ELECTRONIC ENGINE CONTROL OPERATING THE TRACTOR 3. Press the switch (A) side and then release the switch. 4. Press again and hold down the switch (A) side (2.5 seconds) until the buzzer sounds and then release the switch. (A) Increase speed (B) Decrease speed 6. If the switch is released and not operated for 4 seconds, a continuous buzzer sounds and the setting is completed. 7. Follow the same procedure as for the (A) side to set the speed for the switch (B) side. NOTE : The set speeds will be stored even after the engine is stopped. Canceling the setting Any of the actions below will cancel the RPM dual memory settings. 1.

For the switch (A) side, when the memory speed is engaged, press the switch (A) again to cancel. For the switch (B) side, when the memory speed is engaged, press the switch (B) again to cancel. 2. When the memory speed is canceled, the speed will return to the speed that is determined by the hand throttle lever (foot throttle). When the switch is pressed, the LCD will display the engine speed that is in effect after memory speed is canceled. 3. Return the hand throttle lever to the lowest speed position. 4. Turn the key switch to . (A) Flashes 5. Press the switch to the (A) or (B) side and set the speed. Pressing and holding down the switch will cause the speed to change continuously.

Pressing and releasing the switch changes the speed by 10 rpm each time. Set the desired engine speed while watching the speed display. 2. Constant RPM Management control Constant RPM Management can be turned or by operating the switch. Pressing the switch turns the control and pressing the switch again turns it . M5091N, M5101N 63