Kubota — 2.1 PTO gear shift lever

PTO PTO MODELS NOTE : When light load, select the position for economical operation. 2. PTO 540/540E/1000 rpm model (if equipped) 2.1 PTO gear shift lever WARNING To avoid personal injury or death: Be sure to observe the PTO shaft speed prescribed for the individual implements. It is extremely dangerous to run an implement at high speed that is meant to be operated at low speed. Use only when this higher rpm is specifically recommended by the implement manufacturer. 1.2 PTO speed limiter NOTE : Move the PTO gear shift lever to and then turn on the PTO clutch control switch, and the rev-limiter indicator lights up on the meter panel.

If the PTO clutch control switch is turned on with the engine rpm higher than the PTO 540E limit level, the PTO clutch indicator on the meter panel starts blinking and the PTO is disabled. After a while, the engine rpm automatically drops below the PTO 540E limit level and the PTO starts functioning. At the same time, the flashing PTO clutch indicator stays . If the PTO clutch control switch is turned but the engine rpm fails to rise with the throttle, return the engine rpm to a lower level. This enables acceleration again. The PTO gear shift lever can be set to either 540 rpm, 540E rpm or 1000 rpm positions. Move this lever to either position with the PTO clutch control switch set to .

(1) PTO gear shift lever positions NOTE : For maximum PTO shaft speeds of various implements, see the implement operator's manual. (1) Rev-limiter indicator (2) PTO clutch indicator 70 M5091N, M5101N PTO gear shift lev- er Engine speed rpm PTO speed rpm 540 2385 540 540E 1764 540 PTO Limitation PTO/Engine speed (rpm) 540E 630/2057