PTO OPERATION PTO (1) PTO clutch indicator (1) PTO shaft cover (2) PTO shaft cap 3. PTO rpm display IMPORTANT : The universal joint of the PTO drive shaft is technically limited in its moving angle. Refer to the PTO Drive Shaft Instructions for proper use. The PTO rpm can be checked on the LCD monitor. PTO MODELS 1. PTO 540/540E rpm model 1.1 PTO gear shift lever WARNING To avoid personal injury or death: Be sure to observe the PTO shaft speed prescribed for the individual implements. It is extremely dangerous to run an implement at high speed that is meant to be operated at low speed. Use only when this higher rpm is specifically recommended by the implement manufacturer. (1) PTO rpm 4.
PTO shaft cover and shaft cap WARNING To avoid personal injury or death: Keep the PTO shaft cover in place at all times. Put back the PTO shaft cap when the PTO is not in use. Before connecting or disconnecting a drive shaft to the PTO shaft, be sure the engine is . The PTO gear shift lever can be set to either 540 rpm or 540E rpm positions. Move this lever to either position with the PTO clutch control switch set to . (1) PTO gear shift lever (A) 540 rpm (B) 540E rpm M5091N, M5101N 69