Kubota — 2. Selecting the top link mounting holes

3-POINT HITCH AND DRAWBAR THE 3-POINT HITCH SETUP THE 3-POINT HITCH SETUP 1. Make preparations for attaching implement. Selecting the holes of lower links on page 72 Selecting the top link mounting holes on page 72 2. Attaching and detaching implements. WARNING To avoid personal injury or death: Be sure to stop the engine. Do not stand between the tractor and implement unless both parking brakes are applied. Before attaching or detaching the implement, locate the tractor and implement on a firm level surface. Whenever an implement or other attachment is connected to the tractor 3-point hitch, check the full range of operation for interference, binding or PTO separation.

Do not exceed the maximum allowable length of either lifting rod, or the lifting rod will come apart and the 3-point equipment may fall. (1) Lower link (2) Lifting rod (3) Split pin (4) Nut (5) Lift rod pin (6) Thrust collar (A) Hole (B) Hole NOTE : The lifting rods may be attached to (A) for greater lifting force. Install the thrust collar in the outside of the lower link. Tighten the nut by hand and fix the nut with the cotter pin. Drawbar on page 73 Lifting rod (left) on page 73 Lifting rod (right) on page 73 Top link on page 73 Stabilizer - turnbuckle type on page 73 Stabilizer - tube type (if equipped) on page 74 Quick hitch - hook type (if equipped) on page 75 2.

Selecting the top link mounting holes Select the proper set of holes. (See Hydraulic control unit use-reference chart on page 83.) If the hydraulic unit is set for draft control, draft response is more sensitive when an implement is connected to the lower set of top link mounting holes. If draft control is not required, it is recommended to use the top set (1). 1. Selecting the holes of lower links There are 2 holes in the lower links. For most operations, the lifting rods should be attached to the (B) hole. (1) Hole set 1 (2) Hole set 2 (3) Hole set 3 72 M5091N, M5101N