THE 3-POINT HITCH SETUP 3-POINT HITCH AND DRAWBAR 3. Drawbar Remove the drawbar if a close mounted implement is attached. 4. Lifting rod (left) By turning the rod itself, the lifting rod varies its length. When extending the rod, do not exceed the groove on the rod thread. (1) Adjusting handle (2) Lock pin (A) “LOCK POSITION” (B) “UNLOCK POSITION” 6. Top link 1. Adjust the angle of the implement to the desired position by shortening or lengthening the top link. 2. The proper length of the top link varies according to the type of implement being used. (1) Lifting rod (A) “GROOVE” 5. Lifting rod (right) WARNING To avoid personal injury or death:
Do not extend lifting rod beyond the groove on the threaded rod. 1. To adjust the length of the lifting rod, lift the adjusting handle and turn to desired length. 2. After adjusting, the lifting rod adjusting handle must be returned and stored in the fore and aft position. 3. When extending the rod using the adjusting handle, do not exceed the groove on the rod thread. (1) Top link (A) “Length of the screw” NOTE : The length of the screw at both ends of the top link must be the same always. 7. Stabilizer - turnbuckle type The stabilizer is used to adjust the lower link width. Rotate the turnbuckle to adjust the stabilizer length.
When adjusting, make sure both the stabilizers are equal in overall length. Turnbuckle locked position After adjusting the stabilizer length, the turnbuckle must remain in the locked position. (1) Lifting rod (2) Adjusting handle (A) “GROOVE” M5091N, M5101N 73