3-POINT HITCH AND DRAWBAR THE 3-POINT HITCH SETUP 7.2 Rotating the turnbuckle 1. Use the hexagonal part of the wrench and the hex wrench handle to rotate the turnbuckle once. 2. Slide the hex wrench handle forward to release it from the turnbuckle. 3. Rotate the hex wrench handle and slide it backward until the hexagonal part is locked on the turnbuckle. 4. Repeat steps 1 to 3 until the desired stabilizer length is achieved. (1) Turnbuckle (2) Set-pin (3) Hex wrench handle (4) Stabilizer Example: turnbuckle (RH) counterclockwise 7.1 Turnbuckle unlocked position 1. Lift the set-pin and slide the hex wrench handle forward. (1) Set-pin (2) Hex wrench handle (A) (B) “SLIDE FORWARD” 2.
Lower the set-pin and make sure the hex wrench handle cannot move past the set-pin tip. (1) Hexagonal part (2) Turnbuckle (3) Hex wrench handle (A) “Rotate” (B) “Slide forward” (C) “Slide backward” NOTE : Adjusting the left hand side stabilizer is done the same way as for the right hand side stabilizer. 8. Stabilizer - tube type (if equipped) Adjust the stabilizers to control horizontal sway of the implement. 1. Turn the outer tube until one of its holes aligns with the inner tube hole. 2. Insert the set-pin to lock the outer and inner tubes.
(1) Set-pin (2) Hex wrench handle 74 M5091N, M5101N Rotating Stabilizer length Lower link width clockwise Shorten Widen Counterclockwise Lengthen Narrow