Kubota — 9.1 Installing ball-joint to implement

THE 3-POINT HITCH SETUP 3-POINT HITCH AND DRAWBAR 3. When readjusting, make sure both the stabilizers are equal in overall length. 9.1 Installing ball-joint to implement 1. Before the implement is installed on the 3-point hitch with quick hitches, it is necessary to install the ball-joints to the implement according to the following instructions. (1) Outer tube (2) Inner tube (3) Set-pin (4) Hole (1) Ball-joint (1) Set-pin (2) Hairpin cotter [A] “ATTACHING” [B] “DETACHING” 9. Quick hitch - hook type (if equipped) WARNING To avoid personal injury or death: Confirm the below when installing the implement: Make sure the hook of the quick hitch is securely locked.

The 3-point hitch with quick-hitch, all of which have claw ends that permit rapid attaching and detaching of implements. M5091N, M5101N 75