Kubota — 3. Mixed control

HYDRAULIC UNIT 3-POINT HITCH CONTROL SYSTEM HYDRAULIC UNIT IMPORTANT : Do not operate until the engine is warmed up. If operation is attempted when the engine is still cold, the hydraulic system may be damaged. If noises are heard when implement is lifting after the hydraulic control lever has been activated, the hydraulic mechanism is not adjusted properly. Unless corrected, the unit will be damaged. Contact your KUBOTA Dealer for adjustments. A standard tractor has the following hydraulic control systems. Choose the most appropriate system for the implement you are using.

3-point hitch control system Position control Draft control Mixed control Float control (1) Position control lever (2) Draft control lever (A) “FLOAT” (B) (C) 2. Draft control This will control the pull of the 3-point implement. As the load on the 3-point hitch changes due to various soil conditions, the draft control system automatically responds to these changes by either raising or lowering the implement slightly to maintain a constant pull. Place the position control lever in the lowest position and set the implement pull with the draft control lever. Remote hydraulic control system 3-POINT HITCH CONTROL SYSTEM WARNING To avoid personal injury or death:

Before using the 3-point hitch controls, ensure that no person or object is in the area surrounding the implement or 3-point hitch. Do not stand on or near the implement or between the implement and tractor when operating the 3- point hitch controls. 1. Position control This will control the working depth of the 3-point hitch mounted implement regardless of the amount of pull required. (1) Draft control lever (2) Position control lever (A) “SENSITIVE” (B) “INSENSITIVE” (C) “FLOAT” 3. Mixed control In draft control, when draft decreases, the implement automatically lowers to increase draft. However, the implement sometimes lowers too much.

To limit the degree to which the implement can be lowered, set the position control lever at the lowest working depth desired for the implement. Lower the 78 M5091N, M5101N