Kubota — 2.1 Front air outlet

WIPER CAB OPERATION 2. Press the bottom half of the wiper and washer switch, washer liquid only jets out. 1. Airflow Air in the CAB and fresh air introduced into the CAB flows as follows. Adjust the air ports to obtain the desired condition. (1) Rear wiper and washer switch IMPORTANT : Do not activate the wipers when the windows are dry, as they may be scratched. Be sure to jet washer liquid first and then activate the wipers. (1) Control panel (2) Recirculation or fresh air se- lection lever (3) Front air outlet (defrost, windshield, foot area) (4) Side air outlet (face, back area) (5) Door air outlet (door area) (A) Inner air recirculation 3. Using the wipers in cold season 1.

While not used in cold season, keep the wiper blades off the windshield to prevent them from being frozen to the windshield. 2. If the windshield is covered with snow, scrape it off the windshield before using the wipers. 3. If the wiper blades are frozen to the windshield and fail to move, be sure to turn the main key switch to and remove the ice from the blades. Then place the main key switch back to . 4. When commercially available cold-season wiper blades are used, make sure their size is the same as or smaller than that of the standard ones. IMPORTANT : In the cold season, the wiper blades and the wiper motor may become overloaded, and cause damage.

To avoid this, be sure to take the above precautions. (1) Fresh air inlet IMPORTANT : Do not pour water directly into the fresh air port while washing the tractor. 2. Air control vent AIR CONDITIONER 2.1 Front air outlet The front air outlets can be independently adjusted as required. To defrost the windshield, rotate the outlets toward the windshield. CAUTION To avoid personal injury: If the window fails to defrost in extreme conditions or becomes cloudy when dehumidifying the CAB, wipe off moisture with a soft cloth. Do not block all the air outlets of the air conditioner. A problem could occur. M5091N, M5101N 93