Maintenance - 70 SK800 Operator’s Manual Procedures p Check before startup and every 10 hours. Change when needed. Check 3 Check air filter service indicator (1). Change filter when red band on indicator is visible. 1 Change 1. Remove cover (5). 2. Remove primary element (3). 2 3. Wipe inside of housing (2) and cover. 4. Insert secondary element (4) and ensure it is seated correctly. 5. Insert new primary element. 4 6. Install cover with dust ejector (6)) facing down. t35om032w.eps 7. Reset air filter service indicator. Engine Compartment NOTICE: Check more often if operating in large brush, grassy conditions, or if machine is being stored. Check for debris every 10 hours.
Remove debris from engine compartment manually. Do not use water or compressed air. Filter, Air t53om017w20.eps NOTICE: Only open air filter housing when red band on indicator is visible. Change the elements. Do not attempt to clean them. • Improperly installed primary element can lead to premature engine failure. • Compressed air or water can damage filter elements. • Tapping filter elements to loosen dirt can damage elements. t53om017w20.eps NOTICE: Only open air filter housing when red band on indicator is visible. Change the elements. Do not attempt to clean them. • Improperly installed primary element can lead to premature engine failure.
• Compressed air or water can damage filter elements. • Tapping filter elements to loosen dirt can damage elements.