. OPERATION TROUBLESHOOTING TOWING THE MACHINE WARNING If any failure should occur in the brake system and the brakes will not work, then be extremely careful. If the machine is towed in the wrong way, there is the danger of an accident that could cause death or injury. Before releasing the brake, always put blocks under the wheels. Only use wire rope that has enough strength for the weight that it is being towed. Do not apply a load to the wire rope suddenly. WHEN ENGINE CAN BE USED 3 - 178 NOTICE Towing is for moving the machine to a place wh ere inspection and maintenance can be carried out, and not for mov ing it long distances. The machine must not be towed for long distan ces.
ne when it has broken down, please contact your Komatsu distributor. For details of the procedure for towing a machi ne when it has broken down, please contact your Komatsu distribut Always keep the engine running when towin g the machine, so that the steering and braking can be used WHEN ENGINE CANNOT BE USED When towing a disabled machine the dista nce should be within 600 m (1968 ft) at a speed of 8 km/h (5 .0 MPH) or less. If the distance is more than the above men tioned, or if more than 1 day has elapsed since the engine tr ouble, be sure to use a trailer for transportation. .
(A fixed time after the engine stops.) The parking brake is automatically applied It is necessary to release the parking brake special measures to ensure safety when , but the brake will then have no effect at all, so it is necessar y to take moving the machine. This is particularly important on slopes . NOTICE If the machine is towed without the engine running, no lubrication oil will be supplied to the transmission. The gears and bearings are rotated, so this may cause them to be damage d. Tow the machine properly according to th e instructions given below. The explanation given here is only to be us ed for a machine that has failed and is to be moved to a safe place for repairs.
It must be moved a maximum of procedure is only for emergency purposes 600 m (1968 ft) and at a maximum speed of 8 km/h (5.0 MP H). This . If the machine must be moved a long distance, use a trans porter. To protect the operator if the towrope or b ar should break, install a protector plate to the machine bein g towed. If it is impossible to use the steering or bra kes on the machine being towed, then do not have anyone sitting in the operator's seat. Before towing, check that the tow rope or bar are in good condition, and that they have ample strength for the towing operation.
If the machine being tow or bar must be of a strength of at least 1.5 ed may get stuck in mud or may have to be towed uphill, the tow rope times greater than the weight of the machine being towed. Keep the angle of the towing line to the mini mum. Operate the machine so that the angle does not becom e greater than 30 deg. from the straight line. If the machine is moved suddenly, the tow rope or bar will be subjected to an excessive load, and it ma y break. Start the machine gradually and travel at a constant speed. Normally, use a towing machine of about t he same capacity as the machine being towed. The towing machine must have ample brake capacity, weight, a on the tow road. nd rimpull.
Check that both machines can be controlled on sl opes and