. OPERATION TROUBLESHOOTING METHOD OF RELEASING PARKING BRAKE WARNING area is safe. If it is engine will not run for some reason, use the following methods to release the parking brake and tow the machine. 3. This will release parking brake (1). 3 - 179 control and braking power. Another method is to use a secon d towing machine at the re ar of the failed machine. In this way, it is pos sible to prevent the failed machine from g oing out of control and tur It is impossible to d etermine the drawbar pull needed for various conditions.
The minim um drawbar pull may be sufficient on horizo ntal, flat ground, but the m aximum drawba r pu ll is needed on slopes When towing a faile d machine, please contac t your Komatsu When releasing the p arking brake, stop the machi ne on level grou nd a nd check that the surro necessary to release t he brake on a slope in an em ergency, block th e tire s before starting the op If the parking brake is released, the brake cannot b e used, so check the s afety carefully when mo I f t h 1. Turn to remove co ver plug (2) of parking bra ke (1) on the fro side of the final dr 2. Loosen adjustme nt bolt (4) and locknut (3) inside the sprin chamber until a cle Lock nut (3):
Widt Adjustment bolt (4 chamber until a cle arance is formed between the disc and pa h across flats; 20.8 mm (0 ): Width across flats of h 8.1 mm (0.319 in) .8 in) exagonal socke NOTICE After releasing the parkin g brake and moving the mach ine, it is necessar y to adjust the parking brake again. Please contact your Komatsu distributor to h ave the parking brake adjuste d.