Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING 3 - 180 It is dangerous to charge a bat tery when installed on a machine. Make sure that it is removed before c harging. e battery, stop the engine and turn the ition. When checking or handling th starting switch key to OFF pos The battery generates hydroge n gas, so there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulf uric acid, and it will attack your clothes and skin. If it gets on your cloth es or on your skin, immediately wash it off with a large amount of wate r.

If it gets in your eyes, wash it out with fresh water and consult a doct or. ays wear safety glasses and rubber When handling batteries, alw gloves. When removing the battery, fir st disconnect the cable from the ground (normally the negative (-) termi nal). When installing, install the positive (+) terminal first. If a tool touches the positive te rminal and the chassis, there is danger that it will cause a spark, so be extremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. When removing or installing th e terminals, check which is the positive (+) terminal and which is the ne gative (-) terminal.

REMOVAL AND INSTALLA TION OF BATTERY Before removing the battery , turn the battery disconnect switch Before removing the battery , remove the ground cable (normally connected to the negative ( -) terminal). en the positive terminal and the f sparks being generated. connect the ground cable last. If any tool touches betwe chassis, there is a hazard o When installing the battery,