Komatsu — IF THE GEAR SHIFT LEVER OF THE TRANSMISSION HAS ANY TROUBLE

. OPERATION TROUBLESHOOTING STARTING THE ENGINE CAUTION cables in the positive (+) according to the following 3 - 183 Check that the gearshif t levers on both the normal machine a nd problem machine are at the P (Parkin g) position. Check also that all levers are at neutral 1. Make sure the cl ips are firmly connected to the b attery terminals. igh idle speed. 2. Start engine of t he normal machine and run it at h 3. Turn the starting switch of the failed machine to S TART position and start the engine If the engine doe sn't start at first, try again after 2 minutes or so.

DISCONNECTING THE BOOSTER CABLES After the engine has started, disconnect booster c reverse order in which they were connected. After the engine ha reverse order in whi 1. Remove 1 clip of problem machin 2. Remove the othe terminal of the n 3. Remove 1 clip terminal of the n 4. Remove the othe terminal of the p 1. Remove 1 clip of booster cable (B) from the engine e. 2. Remove the othe r clip of booster cable (B) from the ormal machine. of booster cable (A) from the ormal machine. 4. Remove the othe r clip of booster cable (A) from th roblem machine. IF THE GEAR SHIFT LEVER OF THE TRANSMISSION HAS ANY TROUB I f er of the transmission has any trouble, operate the machine ac 1.

Decelerate the m achine with the brake and stop i t on a safe place. RKING). en if the gear shift lever is operated. "DF10L4" of the action code "E03", operate the machine 2. Set the gear shif t lever to N (NEUTRAL) or P (PA 3. In some trouble modes, the gear is not shifted ev en if the gear shift lever is operated. In this case, perf If the character according to the 1) Set the gear 5 seconds. 2) By moving th to its flashing orm the following procedure. display shows the failure code following procedures.

shift lever to the N (NEUTRAL) o r P (PARKING) position and hold it i n the position for at least e gear shift lever to any of F5 to F 8 or any of R1 to R4 after the shift ind icator's lighting changes , the machine travels at fixed ge ar speed of F2 or R2. Move the mac hine to a safe place. ncy escape function does not wo rk in some cases depending on the