Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WARNING water, see 4 - 20 Coolant is toxic. When open the dr ain valve, be careful not to get coolant o If it gets in your eyes, flush your ey es with large amount of fresh water and see a d When changing the coolant or wh en handling the cooling water containin g coola nt that has bee n drained during repai r of radiator, please contact your Koma tsu distributor or request a specialis t company t o carry out the operation. Coolant is toxic. Do not let it flow into drainage ditc hes or spray it onto the ground surface. COOLANT is already diluted wit h distilled water, so it is not flammable.

( For details of the distilled "COOLANT AND WATER FOR D ILUTION (PAGE 4-5)"). Check t he density with a COOL ANT tester. Prepare a hose to use when fillin g with coolant. Prepare a container to catch dr ained coolant minimum 40 liters (10.57 US gal) capacity 1. Stop the machine on level gr 2. Remove bolts (1) (2 pieces) t 3. Check that the cooling wate enough to make it possible to t ouch the radiator cap surface by hand, then turn radiator cap (3) slowly until it contacts the re. stopper to release the pressu 4. Following this, push radiator c ap (3), turn it until it contacts the stopper, then remove it. 5.

Prepare a container to catch t he coolant and open drain valve (4) at the left of the fuel tank t 6. After draining the water, close water. 7. When the radiator is full, start the engine, and run it at low idle. Keep the engine running at l coolant temperature reaches 8. Stop the engine, open drain v 9. After draining the coolant, cle For the cleaning method, detergent liquid. Close drain valve (4). 10. 11. Add coolant through the wate r filler port up to the mouth of the port. For details of the coo DENSITY TABLE". 12. To remove air in the coolant, ru n the engine for 5 minutes at low idle and for another 5 minutes (While running the engine, lea ve the water filler cap removed.)