Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of coolant is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than SUPERCOOLANT (AF-NAC).

If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of coolant, always keep the density of coolant between 30% and 64%. When selecting coolant, investigate the lowest temperature in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it approximately 10 ° C (50 ° F) below lowest temperature. The density must be over 30% at least.

If the density of obtained coolant is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, please contact your Komatsu distributor. Coolant density table 4 - 19 Immediately after th e engine i s stopped, th e coolant is at a high temperatu re and th e radiator is under high interna l pressure. If the cap is r emoved to drain t he coolant in this condition, t here is a danger of burns. Wait for the temperatur e to go down, then turn t he cap slowly t o release the pressur e before removing it. The c leanin g is carr ied out wi th the engin e running.

When standin g up or leaving t he operator's seat, set t he gear shift lever to the P (Parking) po sition. For d etails o f startin g the engi ne, see "CHECK BEFORE STARTING ENGIN E (PAGE 3-83)" , "STARTING ENGINE (PAGE 3-101)" in the OPERATION s ection. e machine when the engine is running. Neve r enter the area behind th e machine when the engine is running. Stop th e machine on level gr ound when cleaning or changing the coolant.

Clean t he inside of t he coolin g system, change the coolant accordin g to the table below Coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine SUPERCOOLANT (AF-NAC) Every 2 years or every 4000 hours whichever comes sooner Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Density (%) 30 36 41 46 50 54 58 61 64