. MAINTENANCE SERVICE PROCEDURE Thickness of 1 shim: 0.2 mm (0.008 in), 0.5 mm (0.020 in) CHECK AND TIGHTEN WHEEL HUB NUT AND HUB BOLT distributor. 4 - 56 CHECK AND ADJUST BALL JOINT CLEARANCE Check and adjust all locations w ith ball joints at the links of the work equipment. Check for any play in the ball joi nt, and if the axial p lay i s more than 1 mm (0.039 in), adjus Prepare a thickness gauge . Remov e all the shims from t . Tighte n the caps with bolts ( 1) to make the sam e clearance the left and right. re the clearance with . Measu ore than this dimensi on, and tighten the cap. NOTICE Loose whee l hub nuts and hub bolts (1) will result in shortened life of ti or other trou bles. .
Carefu lly check for loose bol ts (1). When checking for loose bol the tightening direction to ch Tightening torque: 610 to 76 (62.5 to 7 checking for loose bol ts (1), always turn the b olts (1 tening direction to ch eck. 5 Nm 8.0 kgm , 452.1 to 564.2 lbft) ce all the hub bolts. 564. . If a hub bolt is broken, repla ce all the hub bolts CHECKING WHEEL RIM, LOCK RING AND SIDE RING FOR CORROSION AND W If t he whee l rim, lock ring and sid e ring are heavily c orroded, as k the t ire m anufacturer or yo ur Komatsu dis tributo for inspecti CHECK PARKING BRAKE 1 2 . Set the machine on a dry do wnhill slope, set the gearshift le to the hold th .
If any P (Parking) position, a nd check if the parking brake c e machine in position problem is found, . please contact your Koma