. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING cause burns. Wait for the 1. Open oil filler (F). 119.3 lbft} 4 - 57 EVERY 500 HOURS Maintenance for every 50 and 250 hours servic e shoul d be c arried out at the same time The parts and oil are at high temperature immediately after the engine is stopped, and ma before starting the work. ler cap, turn it slowly to release the internal pressure, then remove it. temperature to go down before starting the work. When removing the oil fil ler cap, turn it slowly to re lease t he internal Refill amount of oil: 23 Prepare a filter wrench 2.
Set the container to c atch the oil immediatel y unde r drain plug (P) on the rear right s 3. Loosen drain plug (P 4. Check the drained particles or foreign distributor. 5. Install drain plug (P). Tightening torque: 11 6. Using a filter wrench, turn filter cartridge (1) counterclockwise 7. to remove it. In particular, if this o peration is carried out immediately after stopping the engine, a for 10 minutes before Clean the filter holde large amount of oil will come out, so wait starting the operation. r, coat the Sealing surface of a new filter 8. cartridge with engine When installing, brin filter holder, then tigh turn. oil, then install it to the filter holder.
g the seal surface into contact with the ten a further approximately 3/4 turn of a