Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE filler (F) until the oil level is between the marks on the dipstick (G). 10. Run the engine at idle for a short time, then stop the engine, 9. After replacing the filter cartridge, add engine oil through oil and check that the oil level is between the marks on the dipstick. For details, see "CHECK ENGINE OIL PAN LEVEL, ADD OIL (PAGE 3-89)". REPLACE FUEL PREFILTER CARTRIDGE WARNING 1. Open the engine side cover on the left side of the machine. 2. The fuel prefilter forms 1 unit with the water separator and is at the rear of the engine. 3. Remove connector (1) and clamp(2).

After removing the connector, cover the connector terminals with a vinyl bag or tape to protect them and prevent them from becoming dirty. 4. Set the container under the filter cartridge (3) to catch the drained oil. 4 - 58 After the engine has been ope rated, all parts are at high temperature, so do not replace the filter im mediately. Wait for all parts to cool down before starting the operation. side the engine fuel piping system when the engine is running. High pressure is generated in side the engine fuel piping system when t When replacing the filter, wa it for at least 30 seconds after stopping th e engine to let the interna l pressure go down before replacing the filter. close.

Do not bring any fire or flame NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has high ly efficient filtering ability . When replacing the filter cartridge, always use a genui ne Komatsu part. The common rail fuel injectio n system used on this machine consists o f more precise parts than the conventional injection pump and nozzle. If any part other than a genui ne Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay m ore attention than normal to the entry of dirt.

If dirt is stuck to any part, use fuel to wash it off completely. Container to catch the fue Prepare a filter wrench