. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the bottom of cup (4) of the fuel (1) and move it forward 4 - 59 5. Remove hose (6) connected t 6. Using a filter wrench, turn filte to remove it. 7. After removing the cartridge, t installed to the bottom of the c cup is used again. If it is dam 8. Install cup (4) to the bottom o When doing this, always repla Tightening torque for cup: When replacing the seal ring, before installing it. Check that drain plug (5) at t 9. prefilter is tightened securely. Tighteningtorque: 0.2 to 0.45 lbft)} Clean the filter holder. 10. NOTICE When filling the filter cartridge with fu cap (A) fitted. Cap (A) acts to prevent the entry of di 11.
Fill the filter cartridge with clea (B) in the new filter cartridge. n fuel through the 8 small holes e of the filter cartridge with clean ) and install to the filter holder. 12. Coat thinly the packing surfac oil. 13. Remove filter cartridge cap (A 14. When installing, tighten until t he packing surface contacts the seal surface of the filte r holder, then tighten it 3/4 of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lea d to leakage of fuel. If the filter cartridge is too loose, fue l will also leak from the packing, so always tighten the When tightening with a filte r wrench, be extremely careful not to dent or damage t 15.
Connect removed connector ( 16. When replacing the standard f uel filter cartridge (every 1000 hours), replace the cartr idge and bleed the air. For details, see the items in "REP LACE FUEL MAIN FILTER CARTRIDGE (PAGE 4-63 )". 17. Start the engine, check that th ere is no leakage of fuel from the filter seal surface or water separator mounting surface, then run for approxim ately 10 minutes at low idle. PROCEDURE FOR BLEEDING AIR 1. 2. 3. Fill the fuel tank with fuel. Open the engine side cover o Loosen and pull out feed pum and backward. The plug on the side surfac not need to be removed. Keep moving knob (1) until 4. After bleeding air, push in and