. MAINTENANCE SERVICE PROCEDURE CHECK CIRCLE GUIDE CLEARANCE, ADJUST WARNING NOTICE 4 - 60 If there is no clearance betwee n the root of the teeth (or the tip of the teeth) o f the pinion gear of the c ircle rotator and the tip of the t eeth ( or the roo t of the t eeth) of the circle gea r after maintenance has been carried out, replace the guide. When r aising the blade , do not raise it higher than n If the condition remains a s below even after maintenan ce is carried out, replace the c ircl e guide.
When t here i s no clear ance (R) between the circle an When t here is no clear ance between the root of the t eeth (or the tip of the teet h) of the pinion gear of th e circle rotator and the ti p of th e teet h (or the root of t he teeth) of the circle Prepar e the followin Feeler gaug Shims (thickness: 1 mm (0.039 in), 0.5 mm (0. CHECKIN G 1. t 2. 1. Raise the blade an d use a feeler gauge to me asure clearance (P) b etween the bottom fac e of the drawbar a nd he to p fac e of the swing circle as shown in the diagram. The standard clearance is 1.5 ± 0.5 mm (0.059 ± mm (0.05 ± 0.02 0 in). 2.
Keep the b lade rais ed and use a feeler gauge to measure clearance (Q) F ( front) and (Q) R (rear) between the circle and circle gu ide as s hown in the diagra m when force is applie d at th e rear. Standard clearanc es (Q) F and (Q) R are as f (Q) F = 0 mm, (Q) R = 1.5 mm (0.059 in), or ( Q) F = (Q) R = 1 mm ( 0.039 i