. MAINTENANCE SERVICE PROCEDURE PROCEDURE FOR BLEEDING AIR 1. Fill the fuel tank with fuel. 2. Open the engine side cover on the left side of the machine. 3. Loosen and pull out feed pump knob (1) and move it forward and backward. The plug on the side surface of the fuel prefilter head does not need to be removed. Keep moving knob (1) until it becomes heavy. 4. After bleeding air, push in and tighten knob (1). REPLACE TRANSMISSION OIL FILTER CARTRIDGE WARNING 1. Set the container under the filter cartridge to catch the drained oil. 2. Using the ring wrench, turn filter cartridge (1) to the left to remove it. 3.
Clean the filter holder, coat the seal surface of the new filter cartridge thinly with clean engine oil, then install to the filter holder. Tightening torque: 49 to 59 Nm (5 to 6 kgm, 36.2 to 43.4 lbft) 4 - 64 7. When install ing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten i t 3/4 of a turn. If the filter ca filter cartridg rtridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. I f the e is too loose, fuel will also leak from the packing, so always tighten the correct amount. 4-64)". 8. After comple ting replacement of filter cartridge (1), bleed the air from the sys tem.
For details, see "PROCEDURE FOR BLEEDING AIR (PAGE 9. After comple ting the air bleeding, start the engine and check that there is no leak age of fuel from the filter seal surface. If th repeat Steps If any damag it. ere is any leakage, check the tightening condition of the filter cartridg e. If there is still fuel leakage, 1 to 3 to remove the filter cartridge, then check the packing surface f or damage or embedded dirt. e or embedded dirt is found, replace the cartridge with a new part an d repeat Steps 4 to 8 to in stall The parts and oil a re at high temperature immediately after the engine is stopped, and may caus e burns. Wait for the temperature to go down before starting the work.
Prepare a ring