Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK LOOSENESS, PLAY OF BALL JOINT AT FRONT OF DRAWBAR joint will break. CHECK AND ADJUST TOE-IN When no side slip tester is available, use the following the wheels. Be sure to drive straight at least a few meters before parking. 2. Measure the height from the ground to the center of the front wheel axle. 3. Mark the same dimension as measured in step 2 at about the center position of the tire width. Use the same procedure to mark both the left and right tires. 4. Measure the distance between the two marks. This distance is called "A". 5.

Next, drive the machine forward slowly to move the marks on the tire to the rear, and stop the machine when the marks come to the same position as the height from the ground to the center of the front axle. Always travel forward when doing this. 4 - 68 Turn nut (1) at the mounting portion of the ball joint a the drawbar to chec k if it is loose. If it is loose, tighte Check for play of th e ball joint, and if the play to the fr is more than 2 mm (0.079 in), remove a shim and ad 2 mm (0.020 to 0.07 If it is tightened with out any clearance, there is danger HOW TO MEASURE Check toe-in and a procedure. on a level ground without steering