. MAINTENANCE SERVICE PROCEDURE CLEAN FINAL DRIVE BREATHER REPLACE HYDRAULIC TANK FILTER ELEMENT WARNING 4 - 67 1. Stop t he engine and wait for t he temperatur e at all parts to go down 2. Remove all mud and dirt from around the b reather. 3. Remove the bre ather and fit a cover t o the breathe r mounting hole t o prevent d irt from entering. 4. Soak the breathe r in flushing l iquid an d was h it. 5. Install the breath The parts a nd oil are at high temperatu re immediately after the engine i s stopped, and may cause bur ns. Wait for the temperature to go down before start 1. Remove bolt (1), then remove cover ( 2). 2. Remove bolts (3 ) to take cove r (4) off. 3.
Take out the ele ment, clean th e removed p arts and the inside of the filter case, then install a new element 4. Install cover (4) and bolt (3). and bolt (1). 5. Install cover (2)