. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (4) off. At this time, cover force of gas 8. Pull up the top of rod (6), and remove spring (5) and strainer (7). part. specified level. For details, see "CHECK OIL REMARK 4 - 72 7. After draining t he oil, remove bolts (3) ( 6 pieces) to t ake cover le pushing down cover ( 4), remove b 9. Remove any di rt stuck to strainer (7), th en wash in cl ean diesel il. If strainer (7) is broke n, replace it w ith a new 10. Refit strainer (7 ) by inserting it into tank projecting p 11. Assemble so th at the protruding portion at the botto m of cover g (5) down, and then tigh ten with bolt 12. Install drain plu ue:
118 to 162 Nm {12 t o 16.5kgf·m, 86.8 to 119.3 lbft} 13. Pour in the spe cified amount of engine oil from oil fil 14. After filling wit h oil, check that the oi ANK, ADD OIL (PAGE 15. Install oil filler ( LEVEL IN Use the supplied h ose to prevent oil from s praying out i nto the surroundin 16. If the oil level is correct, tighten the cap of oil filler (F ), then remove the