. MAINTENANCE SERVICE PROCEDURE CHECK FUEL SPRAY PREVENTION CAP FOR LOOSENESS AND HARDENING OF RUBBER ask your LUBRICATING WARNING 4 - 78 The fuel spr ay prevention caps (12 places) on the fuel injection pip ing and both ends of the high-pressure to prevent t he fuel from c oming into contact with high-temperatur e parts of the engine and causing a fire should leak or spray out. Check visually and touch by hand to ch eck that there are no missing caps, loos hardening of the rubber. If there are any problems, the parts m rry out replacement. ust be replaced.
In this case, please Komatsu di stributor to ca Set the ge ar shift lever to the P (Parking) position and fix the front and rear frames by using the articulate lock pin. Lower the work equipme nt to the ground and stop the engine. Grease on flat ground. 1. Using a grease pum p, pump in grease through the grease fitt 2. After gr easing, wipe off any old grease that was pushed out. Drive shaft