JCB — Service Manual Backhoe Loader

Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the attachments to the ground and stop the engine. Clean the machine using water and/or steam. Do not allow mud, debris etc to build upon the machine, pay particular attention to the following areas: 1 Backhoe hoses passing through mainframe. 2 Around twin slew rams. 3 Twin ram slew recess in chassis (centremount). 4 Kingpost slide rails (sideshift). 5 Kingpost hose tray and bottom ‘shelf’ (sideshift). 6 Recess between slew ram and kingpost casting (sideshift). S272900 Stabiliser cavities can become clogged when operating in soft/wet ground conditions.

Remove and clean away all debris that may have built up. Do not allow mud to build up on the engine and transmission. Make sure the radiator grille is not clogged up. ! WARNING Airborne particles of light combustible material such as straw, grass, wood shavings, etc. must not be allowed to accumulate within the engine compartment or in the propshaft guards (when fitted). Please inspect these areas frequently and clean at the beginning of each work shift or more often if required. Before opening the engine cover, ensure that the top is clear of debris.

S272880 5-3-1-12/2 Avoid using neat detergent - always dilute detergents as per the manufacturer's recommendations, otherwise damage to the paint finish may occur. It is important to note that excessive power washing can cause damage to the seals or bearings. Take care during routine machine washing not to direct high power water jets directly at oil seals or universal joints. Note: The machine must always be greased after pressure washing or steam cleaning. Always adhere to local regulations regarding the disposal of debris created from machine cleaning. The illustrations show some of the areas that must be thoroughly cleaned as required.

S272890 9803/3280 Issue 1 Section 3 Routine Maintenance Section 3 1 - 2 1 - 2 Cleaning the Machine