Service - 66 SK600 Operator’s Manual Procedures p Charge 1. Park service vehicle close to disabled equipment but do not allow vehicles to touch. 2. Engage parking brake in both vehicles. 3. Turn ignition switch off in both vehicles and turn off all electrical loads. 4. Disconnect machine controller, if equipped. 5. Inspect battery in disabled machine (B) for signs of cracking, bulging, leaking, or other damage. 6. Connect red positive (+) jumper cable clamp to positive (+) post of battery (2) in disabled machine. IMPORTANT: Some equipment may have a positive jumper cable terminal (1) located externally. If so equipped, connect red positive (+) jumper cable clamp to terminal. 7.
Connect the other red positive (+) jumper cable clamp to positive (+) post of battery in service vehicle (A). 8. Connect black negative (-) cable clamp to negative (-) post of battery in service vehicle. 9. Connect the other black negative (-) cable clamp to engine or frame ground on disabled machine, at least 12” (305 mm) from failed battery, as shown. 10. Operate service vehicle engine at 1500-2000 rpm for a few minutes to build an electrical charge in failed battery. 11. Stop engine in service vehicle. 12. Remove jumper cables from service vehicle, black negative (-) clamp first. Do not allow clamps to touch. 13. Remove black negative (-) cable clamp from disabled engine or frame ground.
14. Remove red positive (+) cable clamp from disabled machine. 15. Reconnect machine controller, if equipped. 16. Start disabled machine.