Caterpillar — Engine Features and Controls

31 Operation Section Engine Features and Controls Failure of Sensors Turbocharger Outlet Pressure Sensor All Sensors Turbocharger outlet pressure sensor (4) provides a signal which corresponds to turbocharger outlet pressure to the ECM. The air/fuel ratio control utilizes the actual engine speed and the turbocharger outlet pressure in order to control the transient smoke level. The ECM can control injection timing and the amount of fuel that is injected. When the throttle is increased and when the engine demands more fuel, the fuel limit is controlled in order to reduce overall smoke levels of the engine exhaust.

A failure of any of the sensors may be caused by one of the following malfunctions: Sensor output is open. Sensor output is shorted to battery” or battery”. Measured reading of the sensor is out of specification. Programmable Monitoring System (PMS) Failure of the Turbocharger Outlet Pressure Sensor The ECM will detect failure of the turbocharger outlet pressure sensor. The operator will be warned of the problem through the diagnostic lamp. The strategies that are related to the boost will be disabled. Engine power will be severely reduced in the event of a failure of the turbocharger outlet pressure sensor.

A failure of the turbocharger outlet pressure sensor will not cause a shutdown of the engine. The Programmable Monitoring System determines the level of action that is taken by the ECM in response to a condition that can damage the engine. These conditions are identified by the ECM from the signals that are produced from the following sensors. Inlet Air Temperature Sensor Coolant Temperature Sensor Engine Coolant Temperature Sensor Engine Oil Pressure Sensor Coolant temperature sensor (1) monitors engine coolant temperature. The output of the ECM can indicate a high coolant temperature through a relay or a lamp.

The coolant temperature sensor is used by the ECM to determine initiation of the Cold Start Condition. Engine Speed/Timing Sensors Fuel Pressure Sensor Coolant Level Sensor Atmospheric Pressure Sensor Table 4 Atmospheric Pressure Sensor Atmospheric pressure sensor (18) measures barometric pressure. A signal is sent to the Electronic Control Module (ECM). Failure of the Coolant Temperature Sensor Table 3 The ECM will detect a failure of the coolant temperature sensor. The diagnostic lamp will warn the operator about the status of the coolant temperature sensor. A failure of the coolant temperature sensor will not cause a shutdown of the engine or any horsepower change.

Coolant Temperature Sensor Activation temperature for the high coolant temperature fault   103 C (217 F) Activation temperature for the very high coolant temperature fault   106 C (229 F) Atmospheric Pressure Sensor Operating pressure range 0 to 116 kPa (0 to 16.8 psi)